[SD/Modeling] Stormreaver Fel Tower: HP Bar Height Issue

[StonemaulMidget]

Hello Hive,

Before I present the problem, I wish to credit Red XIII for his WCII Orc Tower and his permission.

I've recreated his model into a series of Stormreaver Fel Towers for LordPerenolde II's ToD project update, but I have a problem. If you check out the issue in the game itself, you'll see that it's higher than even the

The HP Bar refuses to elevate where I want it, despite my all.

If anyone can teach me how to correct this issue, then all the better.

I've tried reaching out to Red XIII, but he was last seen on October of last year.

EDIT: Actually, forget it. I think I may have solved the issue.
You may delete this complaint.

 

[A]mun]

A problem that has plagued me in the past as well, thankfully Hermit knows:

 

[deepstrasz]

EDIT: Actually, forget it. I think I may have solved the issue.
You may delete this complaint.

Please write the solution so others could fix when they encounter the issue. Don't ask for selfish deletion.

 

[StonemaulMidget]

I don't think I truly "solved" the problem, but it looks sufficient.

Wish to take a look?

 

[Chaosium]

You may have figured it out but the health bar is placed where the overhead ref is, and on the model uploaded in the 1st post, it seems your overhead is way too low, so you just need to put it higher, and calculate extents afterwards

 

[StonemaulMidget]

You may have figured it out but the health bar is placed where the overhead ref is, and on the model uploaded in the 1st post, it seems your overhead is way too low, so you just need to put it higher, and calculate extents afterwards

Thank you. I'll give it a try.